Multilift with internal carriage

Multilift with internal carriages can be used for the continuous height adjustment of equipments, operating units, visual displays etc.
Differently from the standard Multilift there is here no inner profile running out of the telescopic column but a carriage running within the column casing. Thanks to the slots on the carriage it is possible to fit and position any equipment.
The columns can be driven in single or pairwise parallel mode.Aspecial control unit is available which guarantees the perfect synchroinism of several actuators. Possible lifting power up to 3.000 N per actuator for a total standard travel length of 500 mm(special travels upon request).
It is driven by means of a 24 V DC geared moter generally run by a control / transformer unit (230 V AC/120 V DC).

Features
• Height adjustment of instruments and equipments
• Extruded aluminium profiles with longitudinal slot
• Quadruple bearing with POM slide bushing
• High-power DC motor
• Integrated limit switch
• Self locking even under max. loads
• Profiles with clear anodised surface
• Single and syncrhonous operation mode possible
• Customized stroke lenghts upon request

There are no products to list in this category.
Your IP Address is: 3.80.223.123
Copyright © 2019