Toggle Presses, Round Ram

Manual toggle presses with round ram

Toggle presses only produce their rated force at the end of the stroke, the bottom dead centre (BDC). In doing so, the high working pressure of the press is achieved using the toggle mechanism with a relatively low effort (approximately 150N) on the part of the user. Toggle presses are therefore used where the full force of the press is only required over a short distance at the end of the working stroke, e.g. in assembling, punching, riveting, stamping, gluing etc.

These models are available with a force of 5kN, 7,5kN, 12kN, 15kN, 25kN and 30kN.
Throats of 63mm, 100mm and 250mm are possible.
Depend on the model, you can adjust the Daylight from 43 to 375mm.

Extras:
Precision ram adjustment (DP)
Using the fine adjustment, the bottom dead centre (BDC) of the press can be precisely set directly on the ram. The precision ram adjustment is used where highest precision of the insertion depth is required. Ideal for prototype production and series production when delicate, minute setting within the tolerance range is required.
Return travel lock (HS)
With the return travel lock partial strokes – and hence incomplete work operations – are ruled out. Forming, jointing or connecting operations are carried out safely and completely at all times. On the down stroke, the return stroke of the press is blocked. The locking device is not released and the lever is not reset until after completion of the stroke. A release mechanism permits removal of jammed components..
Table bore (TB)
Tool undersides can be seated in the table bore and secured using a transverse screw. The table bore permits rapid tool-changing and greatly reduces setting-up times.
Stroke counter (Z)
with the five-digit stroke counter, the number of items produced can be checked rapidly.

Your IP Address is: 54.86.132.30
Copyright © 2019